All 22 FAQs Guides, newest first

Illustration of a room wall half plastered with a plastering machine, hose, trowel and plaster sacks.
FAQs

Spray Plaster and Machine Plastering Compared With Hand Work

Machine plastering sprays the plaster on and a plasterer still trowels it smooth. How it differs from hand work, where it suits, what manufacturers claim and what hand plastering costs in 2026.

Read guide
Illustration of a blockwork wall partly covered with one layer of plaster, with a trowel, hawk and plaster sack.
FAQs

What Is One Coat Plaster and When Is It Used?

One coat plaster joins the backing coat and finish into one layer. What it is, where plasterers use it, where it falls short, how thick it goes and what it costs in 2026.

Read guide
Three stacked wall samples showing brick, a backing coat and a smooth finish coat beside a trowel and hawk.
FAQs

Bonding, Hardwall and Multi Finish Plaster and What They Are For

Bonding coat, hardwall, multi finish and one coat explained for people reading a plasterer's quote: what each layer is for, which walls suit which, and what to ask about the spec.

Read guide
Two plasterboard sheets meeting at a joint covered with mesh tape, with a tape roll and jointing knife beside them.
FAQs

Scrim Tape or Tape and Joint and How Board Joints Are Finished

How the joints between plasterboard sheets are reinforced and finished, scrim tape under a skim or tape and joint without one, why joints crack, and typical 2026 prices for a quote.

Read guide
A plastered wall with a filled channel beside a plasterer's trowel, hawk and bucket on a dust sheet.
FAQs

Making Good Plaster After Rewiring or New Pipework

Rewiring and new pipework leave channels and holes in walls. Who is responsible for making good, patch versus skim, what to get in writing, and typical 2026 prices.

Read guide
A bathroom wall tiled on the lower half and smooth plaster above, with a bucket and trowel on the floor.
FAQs

Can You Plaster Over Tiles in a Kitchen or Bathroom?

It can be done in some dry areas, but most experts advise against it and shower areas are a no. How a plasterer decides, what the bonding step does, alternatives to stripping, and typical 2026 prices.

Read guide
Stacked sheets of plasterboard of different thicknesses with a tape measure and sanding block beside them.
FAQs

Plasterboard Types Explained and Which One You Need

What plasterboard is, the main types and where each is used, what 9.5mm, 12.5mm and 15mm mean, typical 2026 board and fitted prices, and what to ask your plasterer to specify.

Read guide
A timber-framed cottage with a lime-washed wall section and a bucket and hawk by the door.
FAQs

Plastering in a Listed Building and the Rules to Follow

Plastering a listed building: when consent is needed, what like for like repair means, why lime and cement are not interchangeable, who to ask first, and what to check with your plasterer.

Read guide
An external wall corner with a metal trim being plastered, with a spirit level, a bucket and a loose length of trim.
FAQs

Stop Beads and Angle Beads and Why Plasterers Use Them

What stop beads, angle beads and render beads are, where each goes, galvanised versus stainless steel versus PVC, why corners should not be plastered without them, and what to check on a quote.

Read guide
Stacked broken plasterboard and rubble bags beside an empty skip with a wheelbarrow.
FAQs

How to Dispose of Old Plaster and Plasterboard

Plasterboard and plaster waste must be kept separate. Who is responsible when a tradesperson does the job, how to check a waste carrier, tip rules and charges, and why Artex is different.

Read guide
A smooth plastered wall corner with a dust sheet, a sanding block and a dust mask beside it.
FAQs

Can You Sand Plaster and When Should You?

Yes, plaster can be sanded, but new skim is usually left alone. When light sanding helps, how to limit the dust, why old coatings must never be sanded, and what to ask your plasterer instead.

Read guide
A cross-section of a ceiling with new plasterboard fixed under an older ceiling layer.
FAQs

Should You Overboard or Skim a Damaged Ceiling?

Overboarding fixes new plasterboard over the old ceiling; skimming adds a thin coat to a sound one. Which suits your ceiling, typical 2026 prices, the Artex asbestos point and questions to ask.

Read guide
A masonry wall with dabs of adhesive in rows and a sheet of plasterboard leaning next to it.
FAQs

Dot and Dab Plasterboard and Its Pros and Cons

Dot and dab sticks plasterboard to masonry with dabs of adhesive. What it is, why it is quick, the draught and damp criticisms, how it compares with wet plaster on cost, and questions to ask.

Read guide
A partly rendered house wall in winter with a thermometer, tarpaulin and a work heater nearby.
FAQs

Can You Plaster or Render in Cold Weather?

Frost, minimum temperatures and drying times for render and internal plaster in winter, why trade advice differs, what a good renderer does, and when to wait until spring.

Read guide
Illustration of a room with one plastered wall and one wall of plasterboard sheets beside bare brick
FAQs

Plasterboard or Wet Plaster and Which Is Better for Your Walls?

Plasterboard (dry lining) or wet plaster on masonry: how they differ in cost, time, drying and finish, which suits which wall, and what to ask when a plasterer quotes for one or the other.

Read guide
Illustration of a textured ceiling with a sealed sample bag and a folded stepladder
FAQs

Does Your Artex Contain Asbestos and How Do You Test It?

Artex and textured coatings in homes built before 2000 may contain asbestos. What the HSE says, why you cannot tell by looking, how a sample is tested, what it costs and what plasterers can safely do.

Read guide
Illustration of a house front with two different render finishes, scaffolding poles and a render trowel
FAQs

Silicone Render or Sand and Cement Render for Your House?

Silicone render or sand and cement render: typical 2026 prices per square metre, lifespan, repainting, scaffolding, planning and building regulations, and when each makes sense.

Read guide
Illustration of an empty room with a freshly plastered wall, a clock, a stepladder and dust sheets
FAQs

How Long Does It Take to Plaster a Room?

How long plastering a room takes: days on site for a skim or replaster by room size, how long the plaster takes to dry, what holds the job up and when you can decorate.

Read guide
Illustration of a wall half painted and half freshly plastered with a scraper and wallpaper steamer on the floor
FAQs

Can You Plaster Over Paint or Wallpaper?

Can a plasterer skim over painted walls or wallpaper? What a sound painted wall needs, why wallpaper must come off first, what Artex means for the job and what prep to expect on your quote.

Read guide
Illustration of plasterboard sheets fixed to a wall with taped joints and a jointing knife
FAQs

Can You Paint Plasterboard Without Skimming It First?

Can you paint plasterboard without a skim? What taped and jointed board looks like, when a skim coat is worth paying for, and what to ask a plasterer about the finish you want.

Read guide
Illustration of a wall half tiled and half plastered with a notched trowel and spare tiles
FAQs

Can You Tile Onto Plaster or Plasterboard?

Can you tile onto plaster or plasterboard? How long new plaster must dry, what an adhesive maker says about weight limits and priming, and why wet areas need more than ordinary board.

Read guide
Illustration of an outside wall with render beside an inside wall with smooth plaster
FAQs

Plaster or Render and What Is the Difference?

What is the difference between plaster and render? Where each goes, what they are made of, why old houses need lime, what each costs and which tradesperson to call.

Read guide