Deciding whether to tackle diy plastering or hire a professional usually comes down to the size of the job and your budget. A small DIY job might cost you just £20 to £40 in materials, while paying a professional to skim an average room costs around £600 including labour and materials. Plaster sets very quickly, so mistakes are hard to hide once the wall is painted.
Why plastering is harder than it looks
Many home improvements allow you to work at your own pace. Plastering does not offer this luxury. Tradespeople say the plaster sets fast, so you cannot easily pause halfway across a wall to rest or check your work.
The trade involves several different techniques, and each requires specific knowledge. A skim is a thin finishing coat, a few millimetres thick, applied over sound plaster or plasterboard. A full replaster means hacking off failed plaster and applying a backing coat plus a finish coat, or fixing new plasterboard and skimming it. This second method is known as board and skim.
You might also encounter dot and dab, which is plasterboard stuck directly to brick or block walls on dabs of adhesive. Overboarding involves fixing new plasterboard under an old ceiling to hide damage or create a fresh surface. Older houses often have lath and plaster, which is lime plaster applied to thin timber laths. Knowing which background you are working with dictates the materials and methods you must use.
The physical demand is also high. Applying wet plaster to walls and ceilings requires constant lifting, stretching and sweeping arm movements. Achieving a completely flat surface with sharp internal and external corners takes significant muscle memory and trowel control.
What tradespeople say about do it yourself plastering
Professional plasterers frequently discuss the challenges beginners face. When asked if plastering is hard compared to other home improvements, many call it one of the hardest trades to learn. One professional states that plastering is probably the hardest of all the trade to master. Another points out that a beginner wouldn't be fast enough to get it in before it started to dry.
The common theme is the lack of time. Because the plaster sets fast, timing matters above all else. Tradespeople advise that full walls or ceilings are best left to an experienced plasterer. The scale of a whole room simply overwhelms someone trying to control the trowel and the setting time simultaneously.
Professionals also warn about the consequences of getting it wrong. One tradesperson says work that is not prepared and done properly can be very expensive to rectify. Fixing a wavy wall or a peeling ceiling takes more time and materials than doing the job correctly the first time.
However, the trade is not entirely closed to beginners. One tradesperson notes that the difficulty lies in experience rather than impossibility, and that first attempts often look acceptable once painted. If you want to try, professionals suggest you try one wall first or practise on a small area first to understand how the material behaves.
What a plasterer costs for comparison
Understanding the cost of hiring a professional helps you decide if a diy plastering kit is worth the effort. Plasterers price per job after seeing it, based on the area in square metres, the state of the background, ceiling height and access. The amount of preparation required also affects the price, such as stripping wallpaper, removing loose plaster, sealing painted surfaces or dealing with Artex.
The table below shows typical published prices for 2026 to help you compare the cost of doing it yourself against hiring a professional.
|
Type of plastering job |
Typical cost |
|---|---|
|
Small DIY job (materials only) |
£20 to £40 |
|
Patch repair (small area) |
£100 to £300 |
|
One single wall |
£250 to £400 |
|
Skimming a room |
Around £600 on average |
|
Average plasterer day rate |
£180 to £250 |
These figures are typical published guide prices for 2026 and local quotes will differ. Prices in London and the South East cost more than the rest of the UK. A minimum charge of around £120 to £150 is quoted for small jobs.
If you hire a professional, skimming a room takes one to three days depending on size and complexity. The cost to plaster a room includes both labour and materials. If you do it yourself, a 25kg bag of gypsum finishing plaster costs £10 to £15 and covers about 10 square metres.
Small jobs that suit a beginner
If you want to try plastering diy, start with a patch repair. Filling small holes or repairing dents in plasterboard, well away from any electrics, gives you a feel for the material without the pressure of a large surface area. A patch repair is the sort of small job where doing it yourself is a realistic way to save money.
You can buy ready mixed patching compounds or mix a small amount of finishing plaster. Working on a small area allows you to focus on getting the surface flush with the surrounding wall. If you make a mistake, sanding back a small patch is much easier than fixing a whole wall.
Practising on a spare piece of plasterboard is another good option. This lets you test your trowel angle and pressure before you touch your actual walls. Once you feel confident with plasterboard repairs, some tradespeople suggest trying one wall first, though others say full walls are best left to an experienced plasterer.
Jobs to leave to a plasterer
Full rooms and ceilings require stamina and speed. Plastering a ceiling means working overhead while gravity pulls the wet material down. Ceilings are usually priced separately because of the extra physical effort and access equipment required. A professional is better placed to get a ceiling flat, which matters because lighting shows every lump and ridge.
Older properties need specialist knowledge. If your home has lath and plaster walls or ceilings, putting modern gypsum over the top is a common cause of problems because it can trap moisture. Conservation bodies advise repairing original lime plaster where possible and replacing like for like. Knowing whether to use lime plaster or gypsum is a decision best left to tradespeople who understand historic building fabrics.
External render is also a job for a professional. Render is priced per square metre with scaffolding often a separate line. The materials vary widely, from traditional sand and cement or lime to pebbledash, monocouche and thin-coat acrylic or silicone systems. You might hear the term K Rend, which is a manufacturer's brand name often used loosely for silicone render. Scaffolding is often a separate line on a render quote.
You must also consider building regulations. Where 25 per cent or more of an external wall is re-rendered, re-plastered or re-lined internally, the regulations normally apply and the wall's insulation would normally have to be improved. A professional knows how to meet these requirements. Planning rules also apply to external work. In England, according to the Planning Portal, rendering needs no permission if materials are of similar appearance to the existing house, but does in conservation areas, National Parks, Areas of Outstanding Natural Beauty and the Broads. Listed buildings need consent for any significant work, inside or out. Elsewhere in the UK, or if you are unsure, check with your council.
The risks of dust, ladders and old coatings
Safety is a major factor when deciding whether to do the work yourself. Plastering creates fine dust during preparation and mixing. You must wear adequate dust protection to keep this out of your lungs. Working at height is another hazard. You should not take down or plaster ceilings at height without proper access equipment.
The greatest hidden risk comes from old textured coatings. The HSE says textured coatings such as Artex may contain asbestos in any building built or refurbished before 2000. Homeowners should not sand, scrape or drill suspect coatings and should tell tradespeople about them before work starts.
Work on these coatings is classed as low risk and does not normally need a licensed contractor, but it must be done by people trained to recognise and work safely with asbestos. If you are unsure what is on your ceiling, do not touch it. When in doubt, hire a tradesperson who is trained to work safely with asbestos, and tell them before work starts.
Redoing a poor DIY job
Some tradespeople point out that redoing a poor job costs more than getting it right once. If you make a mess of a wall, a professional may have to spend time putting it right, which adds labour costs to the original price of the job.
Poor preparation is expensive to fix. Skimming over loose, damp or unsealed painted surfaces can make the new coat crack or peel away from the wall, and flaking paint or crumbling masonry will not give a smooth finish.
Using the wrong materials causes problems. Gypsum or cement on old lime walls is a common cause of trouble. Do not dry sand or scrape Artex, because it may contain asbestos. Plastering requires an understanding of what lies beneath the surface, and poor preparation can make the finish fail.
How to hire a plasterer
If you decide that doing it yourself is too risky or time consuming, you need to find a reliable tradesperson. Plastering is not a licensed trade. There is no legal register like the one for gas engineers, so evidence of past work matters. Ask to see photos of their previous jobs or speak to former customers.
Do not rely on a CSCS card as proof of quality. A CSCS card is for construction sites, not proof of quality on domestic work. Instead, look for membership of FIS, which is the trade body for the finishes and interiors sector, or TrustMark, which is the government-endorsed quality scheme.
Under the Consumer Rights Act 2015 work must be done with reasonable care and skill. If not, the customer can ask for it to be put right or seek a partial or full refund. To protect yourself, Citizens Advice suggests you get written quotes from at least three different traders and get a contract in writing.
Citizens Advice also recommends you do not agree to a deposit of more than 25 per cent and you pay by debit or credit card if you can. Paying by card can give you extra protection if things go wrong. You might be able to cancel within 14 days of agreeing a contract if you change your mind. Finally, remember that a trader who carries waste must be a registered waste carrier, and the register is public.
Questions to ask before you decide
When gathering quotes, you need to know exactly what you are paying for. A quote is a fixed price, while an estimate is just a rough guess. Cash-only deals with nothing in writing leave you with no proof of what was agreed and no paper trail if the work is poor.
To avoid hidden costs, make sure your written quotes include all the necessary details. Quotes that omit preparation, ceilings, scaffolding or waste will result in a larger final bill than you expected.
- Check whether VAT is included in the final figure.
- Ask if the price covers all materials and the cost of waste removal.
- Confirm who is providing floor protection and cleaning up at the end of the day.
- Ask how long the job will take and how long the drying takes before you can decorate.
- Agree on how you will check the finish before paying the final balance.
Common questions
Is diy plastering worth the effort?
This depends entirely on the size of the task. For a small patch repair, doing it yourself saves money and costs just £20 to £40 in materials. For a full room, the speed plaster sets makes it very difficult for a beginner to achieve a smooth finish, and fixing mistakes is costly.
Can I learn plastering from a diy plastering kit?
You can buy small kits and tools to practise on a spare piece of plasterboard. Gypsum finishing plaster covers about 10 square metres per bag, so materials are cheap enough to experiment with. One tradesperson suggests trying one wall first, while others say full walls and ceilings are best left to an experienced plasterer.
How much does a plasterer charge for a single wall?
Typical published prices show a single wall costs between £250 and £400 to plaster. This varies based on the state of the background, ceiling height and the preparation required. Small jobs usually carry a minimum charge of around £120 to £150.
Do I need building regulations approval to replaster?
Building regulations normally apply if you are re-plastering, re-rendering or re-lining 25 per cent or more of an external wall internally. When this happens, the wall's insulation would normally have to be improved. A small patch repair is well below that threshold.
Your next steps
If you are still deciding how to proceed, follow these steps to make sure your walls get the right treatment.
- Assess the size of the job to see if it is a patch repair you can try yourself or a full room that needs a professional.
- Check the age of your property and look out for textured coatings or original lime plaster that require specialist care.
- Get three written quotes from local tradespeople to compare prices in your area.
- Ensure every quote includes preparation, materials, waste removal and floor protection.
- Ask for a written contract and pay a deposit of no more than 25 per cent by card.
If you have decided that skimming a whole room or boarding a ceiling is too much to take on, you can find a plasterer near you to get the smooth finish your home needs.
Find a top rated plasterer near you
1,036 plasterers across the UK, each ranked on their Google rating and the number of reviews behind it. Start with your county: